0.4kV SIVACON 8PT Low Voltage Switchgear for power distribution

Product Introduction 

The SIVACON low-voltage switchgear has standard structure applicable to construction and
power distribution sectors.

SIVACON low-voltage switchgear has been developed based on the world’s market demands. It should consider the so-called single handedly standard solution requirements, on the other hand, it also takes into account the local production and brings financial and operation interests.

SIVACON is a switch cabinet, which can be applied to all parts of the world. It can be applied to the maximum rated current to 7400A.On various levels of capacity, it can be used in fixed installation design, insert type design, also can be used to draw out type design.

Modular Design

Each SIVACON is made by completely using standardized and typical modules. All the modules conform to Siemens’ evaluation and design standards in terms of quality.

Structure

The type experiment (TTA) low voltage switch cabinets arranged above the horizontal bus unified switch cabinet 3 poles and 4 poles horizontal bus system its rated current to 7400A, Ipk rated peak withstand current to 375kA, The device compartment is deep enough for various mounting dimensions , The device compartment can be divided into multiple units according to modular structure,

The switchgear can be installed on one side or back to back.The incoming cable can be arranged from the top or bottom, The outgoing cable can be connected in the front or on the back.

Mobile &Flexible

SIVACON satisfies your requirements all the time

The modular technology of SIVACON 8PT-4000 allow it to best adapt to various requirements.
The horizontal bus is arranged above the switchgear in a centralized manner
The device can be mounted into the compartment freely independent of the horizontal bus system and depth of the switchgear.
The functional compartments could be divided as demanded (conforming to the types 1 to 4 specified in IEC 61439-1)
The device compartment is deep enough

Well adaptable to the conditions of the switchgear installation site
Can be mounted against the wall or on the floor
The cable can be arranged to come in from the top or bottom
The horizontal bus is easy for connection
The cable can be connected in the front or on the back